Free Download in gsmxt.com Official Meizu 20 INFINITY Firmware Flash File , for Unbrick Dead after Flash, Repair Stuck on Logo, Screen Unlock, Pattern Unlock, FRP (Factory Reset Protection) / Google Account, etc.
Meizu 20 INFINITY Stock Firmware is useful for fixing issues such as hang on Logo, frp lock, fastboot Mode, display Blank or white after flash, dead recovery, dead after flash etc. for restoring a device to its original configuration. Stock ROMs are often specific to a particular device and are not interchangeable between different devices.
Download Link Meizu 20 INFINITY Firmware:
- Flyme 10.0.3.2A Full OTA: Download
- DRIVER : Download
- Flashing the ROM Will Erase all Your Personal Data including Storage. So we advice You to First take a Complete backup of your Phone.
- Please Do carefully, We are Not Responsible for any Damage to Your Device.
- Must backup NVRAM using this Guide before Doing anything.
- Ensure that Your Device at-least 50% Charge During Flashing Process to Prevent accidental ShutDown.
Important flash Meizu 20 INFINITY Firmware:
- Make sure to DO NOT root your handset by yourself or without any knowledge. The process may damage the device system and your device warranty will void immediately (if any).
- The firmware updating process will take some time. So, please be patient.
- It may delete all of the device data (internal) completely such as contacts, messages, documents, etc. Make sure to take a full back up of your important data before doing anything.
- Keep the Motorola phone battery juice above 50% or you can plug your device into charging as well.
- Connect your device to a working Wi-Fi network for faster and stable software updates.
- Downgrade a Phone
- Upgrade a Phone
- Fix some serious issue in phone
- Remove FRP Pattern and Pin lock
- Fix bootloop and software issue on a Phone
- Completely Re-Installation of board software
- .. etc
How to Install Stock Firmware on Meizu 20 INFINITY:
SLA Enable device this method work only with a signed firehose file, replace it in firmware folder or use official AF tool.- Install QFIL: Download and install the latest version of QFIL on your computer.
- Download the firmware: Download the firmware file for your from above download section.
- Extract Firmware File: once firmware file is downloaded extract the zip file using the 7z or winrar.’
- Install Qualcomm driver: download & Install latest qualcomm 9008 usb driver on your computer
- Boot your device into EDL mode: To put your device into EDL (Emergency Download) mode, follow these steps:
- Turn off your device.
- Hold down the volume up and volume down buttons simultaneously.
- While holding the volume buttons, connect your device to your computer via USB cable.
- Your device should now be in EDL mode.
- Note: if still not in EDL Mod then you have to short test point
- Launch QFIL: Launch QFIL on your computer.
- Load the firmware: In QFIL, click on the “Flat Build” button and select the firmware file that you downloaded in step
- in the Programmer option click browse and locate Prog-firehose-ddr.elf file from firmware folder
- Click load xml option and select all rawprogram and patch xmls
- Start the flashing process: Click on the “Download” button in QFIL to start the flashing process.
- Wait for the flashing process to complete: The flashing process can take several minutes to complete, depending on the size of the firmware file and the speed of your computer. do not disconnect your device from the computer during this time.
- Reboot your device: Once the flashing process is complete, disconnect your device from the computer and reboot it.
